Option Installation 3-13
SIMM Installation
Install a SIMM as follows.
1.
Remove the system unit cover as previously described.
2.
Locate the SIMM sockets (see Figure Section 3-9).
Remove any currently installed SIMMs that are not needed.
CAUTION:
Before installing a SIMM, reduce
static discharge by touching the system's metal
chassis.
3.
Align the notched end of the SIMM with the socket end closest to the front of the
system.
4.
Insert the SIMM at an angle into the socket.
5.
Tilt the SIMM towards the locking tabs using equal pressure at the ends of the
SIMM until it locks into the socket (see Figure Section 3-9).
Figure Section 3-9 Inserting the SIMM
6.
Replace any cables or boards that may have been removed.
7.
Replace the system unit cover.
