- 92 -
Cleaning Your Computer
Always unplug your computer from the power outlet before cleaning it. Do not use liquid or
aerosol cleaners, use a damp cloth instead. Never spray any cleaning product directly on to the
screen.
If you spill liquid on your computer or any device attached to it, switch it off immediately,
unplug the power cord and make sure it is completely dry before switching it on again. Wait
overnight if necessary.
Modem
Only use a modem that has been approved by the national authority of the country in which
the product is sold. Technically and in most cases, the same modem should work in all
countries. Nevertheless, be advised that some countries might have strict laws which forbid
the modem from being used before it is technically approved. Kindly check this information
with your dealer or get an approved modem as a replacement.
Modifications to the Product
Radio Frequency Interference
The manufacturer is not responsible for any radio or TV interference caused by unauthorised
modifications to this equipment.
Safety Warning
The manufacturer is not responsible for any safety hazards caused by unauthorised
modifications to this equipment.
Radio Frequency Interference Statement
WARNING
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorised modifications to this equipment.
Note
This is a Class B digital device. This equipment has been tested and found to comply
within the limits for a Class B digital device, pursuant to the CISPR22 Standard
(CISPR is the acronym for the French name of the International Special Committee
on Radio Interference, IEC). These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio-frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to radio
communications.
There is no guarantee, however, that interference will not occur in a particular installation. If
this equipment does cause harmful interference to the radio or television reception, which can
be determined by switching the equipment on and off to check its effect on reception, the user
is encouraged to try to correct the interference by applying one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the distance between the equipment and receiver.
•
Connect the equipment to an AC power outlet on a circuit separate from the one to which
the receiver is connected.
To meet the CISPR22 Standard, shielded cables and power cords are required when connecting
this device to a personal computer or other Class B certified devices.
