3-28 Option Installation
Procedures are provided on the following optional devices:
IDE devices
−
hard disk drive or CD-ROM reader
diskette drive
−
1.2-MB drive.
IDE Device Cabling
The following procedure explains how to cable an IDE device.
1.
Connect the signal cable connector to the connector on the IDE device.
Take care to prevent bending drive connector pins. Align the cable connector as
shown in the following figure.
2.
Locate an available power connector coming from the power supply.
3.
Connect the appropriate power cable to the power connector on the IDE device.
Figure 3-28 Connecting IDE Device Cables
4.
If you are installing a CD-ROM reader, also connect the audio cable (see the
instructions that come with the reader).
Diskette Drive Cabling
1.
Connect the diskette drive signal cable connector to the signal connector on the
diskette drive as shown in the following figure.
2.
Locate an available power connector.
3.
Connect the power cable to the power connector on the device.
Summary of Contents for POWERMATE P2166
Page 217: ...Index 4 ...