Setting System Board Jumpers B-5
8.
Power on the system. The system displays a system configuration error message.
9.
Power off, unplug the system and monitor, and remove the cover.
10.
Return the jumper block to the Normal Operation position.
11.
If you removed any expansion boards, replace them (see “Replacing Expansion
Boards” in Section 3).
12.
Replace the system unit cover. Reconnect the system power cables and
peripheral devices.
13.
Power on the system.
14.
Run Setup (see “Setting System Parameters” in Section 2).
CLEARING CMOS
If you want to return the system to the factory default settings, use the following procedure
to clear CMOS to the default factory settings.
CAUTION:
Clearing CMOS changes the setup
configuration including hard disk settings.
1.
Power off the system and unplug any peripherals.
WARNING:
The system power must be off
before removing the cover and changing a
jumper setting.
2.
Remove the system unit cover (see “Replacing the Desktop Cover” or “Replacing
the Minitower Cover” in Section 3).
3.
Locate the CMOS Clear jumper J1K2 on the system board (see Figure B-1).
You may have to remove any installed expansion boards to access the jumpers
(see “Removing Expansion Boards” in Chapter 3).
4.
Move the jumper block to the Clear position (see the following figure).
Summary of Contents for POWERMATE P2166
Page 217: ...Index 4 ...
