B-6 Setting System Board Jumpers
Figure B-4 Clear CMOS Jumper
5.
Replace the system unit cover (see “Replacing the Desktop Cover” or
“Replacing the Minitower Cover” in Section 3).
6.
Connect system power cables and monitor.
7.
Power on the system. The system displays a system configuration error message.
8.
Power off, unplug the system and monitor, and remove the cover.
9.
Return the jumper block to the Normal Operation position.
10.
If you removed any expansion boards, replace them (see “Replacing Expansion
Boards” in Section 3).
11.
Replace the system unit cover. Reconnect the system power cables and
peripheral devices.
12.
Power on the system.
13.
Run Setup (see “Setting System Parameters” in Section 2).
DENYING ACCESS TO SETUP
In special cases, you may want to deny the user access to the Setup utility. In this case you
must change the jumper from its default position. Use the following procedure to change
the jumper setting.
1.
Power off the system and unplug any peripherals.
WARNING:
The system power must be off
before removing the cover and changing a
jumper setting.
CMOS Clear
−
J1K2
Normal Operation (Default)
Jumper 4-5
Clear
Jumper 5-6
1 3 1
A B
4
6 4
1 3 1
A B
4
6 4
Summary of Contents for POWERMATE P2166
Page 217: ...Index 4 ...