Setting System Board Jumpers B-7
2.
Remove the system unit cover (see “Removing the Desktop Cover” or “Removing
the Minitower Cover” in Section 3).
3.
Locate the Setup Access jumper J1K2 (B) on the system board (see Figure B-1).
4.
You may have to remove any installed expansion boards to access the jumpers
(see “Removing Expansion Boards” in Section 3).
5.
Move the jumper block to the Access Denied position (see the following figure).
Figure B-5 Setup Access Jumper
6.
If you removed any expansion boards, replace them (see “Replacing Expansion
Boards” in Section 3).
7.
Replace the system unit cover. Reconnect the system power cables and peripheral
devices.
8.
Power on the system.
9.
Run Setup (see “Setting System Parameters” in Section 2).
CLEARING THE PASSWORD
If you set a system password and you forget the password, use the following procedure to
clear the current system password and set a new one.
1.
Power off and unplug the system and any peripherals.
WARNING:
The system power must be off
before removing the cover and changing a
jumper setting.
2.
Remove the system unit cover (see “Removing the Desktop Cover” or
“Removing the Minitower Cover” in Section 3).
Setup Access
−
J1K2
Access Allowed (Default)
Jumper 1-2
Access Denied
Jumper 2-3
3 1 3 1
A B C
6 4 6 4
6
4 6 4
3 1 3 1
A B C
Summary of Contents for POWERMATE P2166
Page 217: ...Index 4 ...
