Setup and Operation 2-3
3.
If installing a multimedia system, connect the speakers as follows.
Locate the right speaker (the controls are on the front) and the speaker cables.
Match and attached the color-coded speaker cables to the speakers.
Plug the speaker jack into the Line Out jack at the rear of the system (see
Figure 2-3).
Connect the AC adapter to the right speaker and to a surge protector or wall
outlet.
Press the power switch. The power lamp lights.
Adjust the volume control as required.
NOTE:
Headphones can be connected to the
jack in the front of the right speaker.
4.
Plug the microphone into the microphone in jack at the rear of the system (see
Figure 2-3).
Figure 2-3 Desktop Speaker and Microphone Jacks
5.
Press the power button to power-on the system (see Figure 2-4). The power lamp
lights green, indicating that the system is in Full-Power On mode.
The system automatically goes into its Power-On Self-Test (POST), and checks
system components. One beep indicates that the system has successfully
completed its power-on test.
If a problem occurs, a series of beeps may sound. If this happens repeatedly after
powering on, power off and troubleshoot the system (see Section 4 for
troubleshooting information.
Summary of Contents for POWERMATE P2166
Page 217: ...Index 4 ...