Setup and Operation 2-9
Use the CD-ROM reader to load and start programs from a CD or to play audio CDs. The
CD-ROM reader has the following controls and indicators:
jack for connecting headphones with a stereo mini-jack plug
volume control for adjusting the headphone volume
busy lamp that lights during read operations
open/close/stop button for opening or closing the CD tray when the power is on.
When playing a CD, press the open/close/stop button to stop the CD.
play/skip button to play a loaded CD. Press again to skip a selection. (This button
is not available on all CD-ROM readers.)
CD tray that opens and closes when the eject/retract button is pressed
emergency eject hole in the front panel for manually opening the CD tray if power
is lost. Insert a paper clip into the hole and press inward to open the tray.
Figure 2-11 Typical CD-ROM Reader Controls and Indicators
To load a disc in the CD-ROM reader, follow these steps.
1.
Press the open/close/stop button. The CD tray opens.
2.
Put the CD, printed side up, into the tray.
3.
Press the open/close/stop button again and the tray closes.
4.
To remove the disc, press the open/close/stop button. The tray opens, allowing
removal of the disc.
Summary of Contents for POWERMATE P2166
Page 217: ...Index 4 ...
