2-22 Setup and Operation
ECP
−
sets the parallel port to the Enhanced Capabilities Port (ECP) mode.
EPP
−
sets the parallel port to the Enhanced Parallel Port (EPP) mode.
Audio Interface
For multimedia systems, this option “Enables” the Vibra 16C audio subsystem. If this
option is “Disabled,” then the I/O resources and addresses that are used to support the
audio interface are freed. The default is “Enabled.”
Hardware Monitor Interface
This option “Enables” or “Disables” the hardware monitor subsystem. The default is
“Enabled.”
PCI LAN Interface
For network-ready systems, this option “Enables” or “Disables” the onboard LAN interface.
The default is “Enabled.”
Advanced Chipset Configuration
When the cursor is placed in the Advanced Chipset Configuration field, you can select it by
pressing
Enter
. The Advanced Chipset Submenu appears allowing parameters which affect
the system performance to be changed.
Advanced Chipset Submenu
The Advanced Chipset Submenu lets you check or change the following chipset parameters.
Base Memory Size
ISA LFB Size
ISA LFB Base Address
Video Palette Snoop
Latency Timer (PCI Clocks)
Banks 0, 1 and 2 SIMM Detected
Base Memory Size
The Base Memory Size field controls the mapping of addresses between “512 KB” and
“640 KB.” The two choices are described as follows.
512 KB
−
directs address mapping between 512 KB and 640 KB to the ISA bus.
640 KB (default)
−
directs address mapping between 512 KB and 640 KB to the
system DRAM. Unless using an ISA expansion board that requires access to this
address range, this field should not be changed.
Summary of Contents for POWERMATE P2166
Page 217: ...Index 4 ...