4-2 Maintenance and Troubleshooting
MAINTENANCE
This subsection contains general information for cleaning and checking the system, key-
board, and monitor.
The system, keyboard, and monitor require cleaning and checking at least once a year, and
more often if operating in a dusty environment. No other scheduled maintenance or lubrica-
tion is required.
WARNING:
Unplug all power cords before
performing any maintenance. Voltage is present
inside the system and monitor even after the
power button is off. All voltage is removed only
when the power cord is unplugged.
System Cleaning
Use the following procedure for cleaning the system.
1.
Power off the system and unplug all power cables.
2.
Periodically wipe the outside of the system, keyboard, mouse, and monitor with a
soft, clean cloth. Remove stains with a mild detergent. Do not use solvents or
strong, abrasive cleaners on any part of the system.
3.
Clean the monitor screen with a commercial monitor screen cleaning kit. Or use a
glass cleaner, then wipe with a clean lint-free cloth.
4.
Local distributors and dealers may sell diskette drive head cleaning kits. These kits
contain special diskettes and cleaning solution. Do not use the abrasive head
cleaning kits (kits without cleaning solution). Insert the diskette immediately after
powering on the system, before the disk boot-up. Allow the diskette drive heads
to clean for about 30 seconds.
Summary of Contents for POWERMATE PRO150
Page 152: ...A 16 Connector Pin Assignments ...
Page 160: ...B 8 System Board Settings ...
