Repair 5-5
SIMM Removal
Remove any optional SIMM sticks from the system board as follows.
1.
Remove the side panel and any full size expansion boards as previously described.
2.
Open the clips at each end of the SIMM connector (see Figure 5-3). Tilt the
SIMM forward, so that the SIMM can be removed from the socket.
3.
Remove the SIMM stick from the system board. Repeat steps 2 and 3 for each
SIMM being removed.
NOTE:
For information on installing SIMM
sticks is in Section 3, “Options”.
Figure
5-3
SIMM
Socket
Clips
Hole
Post
Summary of Contents for POWERMATE PRO150
Page 152: ...A 16 Connector Pin Assignments ...
Page 160: ...B 8 System Board Settings ...