5-8 Repair
3 1/2-inch Diskette Drive Removal
Remove the 3 1/2-inch diskette drive as follows.
1.
Remove the side panel as previously described (see “Side Panel Removal”).
2.
Unplug the diskette drive power cable and signal cable from the diskette drive
(see Figure 5-7).
NOTE:
When reinstalling the diskette drive,
note that all power cables are keyed to fit only in
the correct position. The red edge of the diskette
drive signal cable is positioned as shown.
Figure 5-7 3 1/2-Inch Diskette Drive Cables
3.
Remove the 3 1/2-inch drive bracket as previously described (see “3 1/2-Inch
Drive Bracket Removal”).
4.
Remove the four screws, two on each side, from the 3 1/2-inch drive bracket (see
Figure 5-8).
3 1/2-Inch
Diskette Drive
Connector
Power Cable
Diskette Drive
3 1/2-Inch
Red Edge
Summary of Contents for POWERMATE PRO150
Page 152: ...A 16 Connector Pin Assignments ...
Page 160: ...B 8 System Board Settings ...
