5-10 Repair
3.
Remove the 3 1/2-inch drive bracket as previously described.
4.
Remove the four screws securing the 3 1/2-inch drive to the bracket. Slide the
3 1/2-inch drive out of the bracket (see Figure 5-10).
Figure 5-10 Removing the 3 1/2-Inch Drive
5 1/4-Inch Device Removal
Remove a 5 1/4-inch device (CD-ROM reader or other device) from the 5 1/4-inch device
cage as follows.
1.
Remove the side panel and front panel as previously described.
NOTE:
The 5 1/4-inch devices are installed with
drive rails.
2.
Disconnect the device signal and power cables from the inside of the system unit.
(If removing a CD-ROM reader also disconnect the audio cable.)
3.
Remove the 51/4-inch device by releasing the guide rail tabs and slide the device
out from the front of the system unit.
Summary of Contents for POWERMATE PRO150
Page 152: ...A 16 Connector Pin Assignments ...
Page 160: ...B 8 System Board Settings ...
