5-14 Repair
Power Supply Removal
Remove the power supply as follows.
1.
Remove the side panel as previously described (see “Side Panel Removal”).
2.
Remove the internal drive cage as previously described.
3.
Unplug the two power cables attached to the system board's connectors. See
Appendix A for connector locations.
4.
Unplug the power cables from all installed devices.
5.
Cut any tie wraps that may be securing the power cables to the system unit chassis
or drive brackets.
6.
Remove the three screws securing the power supply to the system unit chassis
(see Figure 5-16).
CAUTION:
Hold the power supply while
removing the last screw to prevent the power
supply from falling and damaging the other
system components.
Figure 5-16 Power Supply Screws
7.
Remove the power supply from the system unit.
Power Supply
Screws
Summary of Contents for POWERMATE PRO150
Page 152: ...A 16 Connector Pin Assignments ...
Page 160: ...B 8 System Board Settings ...