Setup and Operation 2-7
STARTING UP
Press the power button (see Figure 2-8) to power-on the system. The power lamp lights
green, indicating that the system is on.
The system automatically goes into its Power-On-Self-Test (POST), and checks system
components. One beep indicates that the system has successfully completed its power-on
test.
If a problem occurs, a series of beeps may sound. If this happens repeatedly after powering
on, power off the system and Troubleshoot.
If a problem occurs and is not indicated by beeps, power off the system and troubleshoot.
NOTE:
If the system displays a message
indicating that system settings have changed, run
Setup (see “System Configuration” later in this
section).
Figure 2-8 System Buttons, Lamps, and IR Window
WINDOWS NT 3.51 AND DRIVER INSTALLATION
Follow these steps to install Windows NT workstation on your computer for the first time.
Windows NT Setup automatically guides you through each of these steps. Help for these
steps are provided in the Windows NT Workstation Installation Guide.
NEC recommends that the applications shipped with the system be installed in the following
order. Any selections that are different from the defaults have been identified.
Power Lamp
Disk Lamp
Power Button
Reset Button
IR Window
Summary of Contents for POWERMATE PRO150
Page 152: ...A 16 Connector Pin Assignments ...
Page 160: ...B 8 System Board Settings ...