Setup and Operation 2-13
MPEG Drivers Installation
After you have installed Windows NT, install the Motion Picture Expert Group (MPEG)
driver as follows.
1.
Locate the NEC Utilities diskette labeled “Matrox MGA MPEG Utilities” and
insert it in drive A.
2.
From the Windows NT desktop click on the “File.”
3.
In the File Menu click on “Run.”
4.
Type the following command line in the box.
A:\SETUP
5.
Click on “OK” or press
Enter
.
6.
An introduction screen appears, click on “Continue” or press
Enter
.
7.
In the SoftPEG™ Screen, select the path for the MPEG drivers. The default path
is “C:\SOFTPEG,” click on “Continue” or press
Enter
.
8.
When the “Setup Succeeded!” message appears, click “OK” or press
Enter
.
NOTE:
Two of the icons created with the
Matrox MGA MPEG utilities diskette do not
function. The icon program names are “MPEG
File Player” and “MPEG Disk Player.” When you
click on these icons, the icons give no response.
This completes your Windows NT MPEG driver installation.
SETUP UTILITY
The Setup utility program allows you to enter system configuration information and control
special features of the system.
NOTE:
System ships from the factory with the
correct system parameters for the configuration.
Unless adding optional hardware, run the Setup
utility only to customize the system, such as
setting the security features.
Summary of Contents for POWERMATE PRO150
Page 152: ...A 16 Connector Pin Assignments ...
Page 160: ...B 8 System Board Settings ...