3-14 Option Installation
Processor Installation
Install the processor into the system board’s processor socket as follows.
1.
Remove the processor currently in the system (see the previous procedure
“Processor Removal”).
CAUTION:
Before picking up the processor,
reduce static discharge by touching the metal
frame of the system unit.
2.
Align the notched corner of the processor with the alignment corner in the socket
and insert the processor.
Figure 3-9 Aligning the Processor
3.
Swing the lever down to lock the processor into the socket.
CAUTION:
Remember to either reattach the
heatsink used with the old processor or to install
any new heatsink required for the upgrade
processor.
4.
Check to see if the newly installed processor requires the switches on the system
board to be changed (see Appendix B, “System Board Settings”).
5.
Replace the system unit side panel (see “Replacing the Side Panel” earlier in this
section).
Alignment Corner
Summary of Contents for POWERMATE PRO150
Page 152: ...A 16 Connector Pin Assignments ...
Page 160: ...B 8 System Board Settings ...
