Option Installation 3-15
Video Upgrade
The video board comes with 2 MB of video Window RAM (WRAM). The video board
supports an optional 2 MB video WRAM for a total of 4 MB of video WRAM. Network
configurations come with 4 MB of video WRAM and is upgradeable to 8 MB.
Install the upgrade module into the video board as follows.
1.
Remove the system unit cover (see “Removing the Side Panel”).
2.
Remove the video board installed in the PCI expansion board slot (see Expansion
Board Removal).
3.
Locate the upgrade module connectors on the video board.
CAUTION:
Before installing the video WRAM
module, reduce static discharge by touching the
system’s metal chassis.
4.
Align the connectors on the bottom of the upgrade module with the connectors on
the video board. Press slowly and firmly until the module is seated.
Figure 3-10 Aligning the Video WRAM Module with the Socket
5.
Replace the removed video board (see “Expansion Board Installation” earlier in
this section).
6.
Replace the system unit cover.
NOTE:
After upgrading the video memory,
different video driver can be used to display more
colors at higher resolutions.
Upgrade Module
Connectors
Video Module
Connectors
Summary of Contents for POWERMATE PRO150
Page 152: ...A 16 Connector Pin Assignments ...
Page 160: ...B 8 System Board Settings ...