Option Installation 3-23
3.
Remove the screw securing the drive bracket to the 5 1/4-inch device cage and
slide the bracket toward the rear of the system (see the following figure).
Figure 3-18 Removing the 3 1/2-Inch Drive Bracket
4.
Continue to “Installing the 3 1/2-Inch Drive.”
Installing the 3 1/2-Inch Drive
Use the following procedure if you are installing a second 3 1/2-inch hard disk drive into the
system.
1.
Remove the system unit side panel (see “Removing the Side Panel”).
2.
Remove the 3 1/2-inch drive bracket from the system unit (see “Removing the
3 1/2-Inch Drive Bracket”).
3.
Follow the preinstallation instructions that come with the device, such as setting
jumpers and switches.
4.
See “Device Preparation” for device preparation information.
5.
Insert the hard disk drive so that the connectors are extended out the bracket on
the same end as the standard diskette drive connectors.
6.
Align the holes in the hard disk drive with the holes in the bracket.
Drive
Bracket
Device
Cage
Summary of Contents for POWERMATE PRO150
Page 152: ...A 16 Connector Pin Assignments ...
Page 160: ...B 8 System Board Settings ...