2-24 Setup and Operation
2.
Select
Set Supervisor Password
or
Set User Password
with the up or down
arrow keys.
NOTE:
Once the Supervisor Password feature
is enabled, the Setup Utility can only be accessed
by entering the password.
3.
With the password field selected, press
Enter
.
If you are setting a password for the first time, Setup displays a dialog box
with the following prompts:
Enter new password: [ ]
Confirm new password: [ ]
Type the password (passwords are not case sensitive) and press
Enter
.
Reenter the password and press
Enter
again.
NOTE:
The cursor changes to magenta during
password entry. The characters you enter do not
appear on the screen.
If you are changing a password, Setup displays a dialog box with the
following prompts:
Enter current password: [ ]
Enter new password: [ ]
Confirm new password: [ ]
Type the current password and press
Enter
. Type the new password and press
Enter
. Reenter the new password and press
Enter
again.
4.
Use the left or right arrow key to select
Exit
.
5.
Use the up or down arrow key to select
Exit Saving Changes
. Press
Enter
.
6.
At the prompt aski-ng you to confirm that you wish to exit Setup, press
Enter
.
The password takes effect the next time you power on the system. The next time
you power on you will be prompted for a password. You must enter a password
to access the system.
Clear User Password
If you wish to clear the user password, select the Clear User Password field and press
Enter
.