Option Installation 3-27
Internal SCSI Device Cabling
The following procedure explains how to cable an internal SCSI device.
NOTE:
The appearance of your device may
vary from the one shown.
1.
Remove the termination from the appropriate connector on the SCSI device.
2.
Connect the appropriate connector on the SCSI device cable to the SCSI cable
connector on the SCSI device.
3.
Locate an available power connector coming from the power supply
4.
Connect the power cable to the power connector on the SCSI device (see
“System Power Cables”).
Figure 3-20 Connecting Internal SCSI Device Cables
PCMCIA Device Cabling
The following procedure explains how to cable a PCMCIA device
also known as a PC
card host.
1.
Connect the connectors at one end of the PC card cable set to the PC card. (The
PC card is installed in one of the expansion slots. See “Installing an Expansion
Board” if the card must be installed first.)
The connectors are keyed to fit only one way.
2.
Connect the connectors at the other end of the PC card cable set to the
connectors at the rear of the PC card host.