3-36 Option Installation
Figure 3-30 Securing a Drive in the Upper Drive Bay
8.
Replace the drive cage in the chassis (see “Replacing the Drive Cage”).
9.
Connect the device cables (see “IDE Device Cabling” or “Internal SCSI Device
Cabling”).
10.
Replace the left cover of the system unit (see “Replacing the Covers”).
11.
Run the Setup program to set the new configuration (see “Setup Utility” in
Section 2).
Removing the Drive Cage
Remove the drive cage by following these steps:
1.
Label and disconnect all cables connected to devices in the drive cage.
2.
Remove the two screws securing the drive cage to the rear of the chassis.