Repair 5-7
Figure 5-6 Removing the Drive Cage
5.
Lift the drive cage up slightly to free the large hooked tabs from the slots in the
chassis.
6.
Pull the drive cage away from the chassis.
Internal Hard Disk Removal
To a remove an internal hard disk drive, follow these steps.
1.
Label the IDE device signal and power cables connected to the internal hard disk
and then disconnect them.
NOTE:
When reinstalling the drive, note that all
power cables are keyed to fit only in the correct
position.
2.
Remove the drive cage (see the previous section).
3.
Remove the four screws (two to a side) securing the drive to the drive cage and
remove the drive from the drive cage (see Figure 5-7).
NOTE:
If you are removing a second internal
hard disk, remove the screws from the drive cage
as shown in Figure 5-8.