B-2 Jumper Settings
You can obtain the BIOS Recovery program by downloading it to a diskette from
the NECCSD Bulletin Board System (BBS) or the NECCSD File Transfer
Protocol (FTP) site. See “NECCSD Bulletin Board System” in Chapter 4 for
information on how to download files onto a diskette. See “Internet” in Chapter 4
to access the NECCSD FTP site.
CAUTION:
Jumpers are set correctly at the
factory for the configuration.
If the system requires a jumper change, change
only the setting for that condition. Otherwise,
keep the jumpers at their factory settings.
The following figure shows jumper locations on the system board.
Figure B-1 Locating System Board Jumpers
Changing the Processor Speed
To change the processor speed in the BIOS Setup utility, proceed as follows. NECCSD
recommends using needle-nose pliers to move a jumper.