B-6 Jumper Settings
CS: Cable Select jumper
Not used
Master device
Enabled, DS jumpered (factory default)
Disabled, DS open
Master device with Slave present (if the Slave drive does not use the Drive
Active/Slave Present (DASP-) signal to indicate its presence:
Enabled, DS and CS jumpered
Disabled, CS open
Slave device
Disabled, PK open (factory default)
Enabled, PK jumpered
IBM Deskstar
The IBM Deskstar 6.4-GB and 8.4-GB IDE hard disk drive jumper pins are located
between the power and interface connectors. The default value of the logical head number
can be specified as 15 or 16 by the settings of jumper pins A - I.
IBM Deskstar 8.4-GB Hard Disk
The default logical head number is set to 15 as follows (see Table B-1):
Table B-1 IBM Deskstar 8.4-GB Logical Head
Number 15 Jumper Settings
Jumper Position
Description
I
G
E
C
A
H
F
D
B
Device 0
I
G
E
C
A
H
F
D
B
Device 1
I
G
E
C
A
H
F
D
B
Cable select
I
G
E
C
A
H
F
D
B
Device 0 (forcing
device 1 present)