１８
2.1 Precautions on handling the card
・
It is recommended to ask your sales representative to install this product in your workstation.
Refer to the User's Guide of workstation when installing this product.
・
The electronic components used in this product may be damaged by electrostatic discharge. Take
an appropriate anti-static measures (e.g., by grounding a part of your body) when handling this
product. Do not touch the component side and connector directly with your hand. Hold the rear
panel or edge of the card.
・
Before installing/removing the card in/from the workstation or connecting/disconnecting cables
to/from the product, be sure to power off the workstation and peripheral devices and unplug
the power cable from power outlet.
・
If you drop the conductive material such as a screw or a clip in the workstation and it is hard
to take it out, consult with your service representative or your maintenance service company.
・
To avoid bad influence by radio wave, turn off the cell phone or PHS when handling the product.
CAUTION
Unplug the power cord
If the workstation is running, quit all the applications, power off the workstation
and peripheral devices, and then unplug the power cord from power outlet.
Pay attention to hot surface
Immediately after the workstation is turned off, its internal components are extremely
hot. Make sure that they are fully cooled down before installing the card.
2.
Installing Hardware
