1. System BIOS
Express5800/R120d-1E, R120d-2E Maintenance Guide
84
Chapter 2 Convenient Features
(2/2)
Option Parameter
Descriptions
Thermal Sensor
Disabled
[Enabled]
Enable or disable the thermal sensor
monitoring feature.
If this option is set to
Enabled
and when
abnormal temperature is detected, stops
POST before OS starts and waits until the
temperature becomes normal.
Check previous System Config
[Disabled]
Enabled
Enable or disable the feature to detect
system configuration change.
If this option is set to
Enabled
and the
system configuration differs from the
previous boot, POST stops before OS
booting and displays confirmation message
whether to continue booting. At this time,
POST pauses until user’s response is made.
BMC IRQ
Disabled
[IRQ 11]
Specify whether to allocate interrupt lines for
BMC (Baseboard Management Controller).
Post Error Pause
Disabled
[Enabled]
Enable or disable the feature to suppress OS
booting when POST detects an error, until
user's response is made.
When set to
Disabled
, continues OS booting
regardless of user's response even if an error
is detected during POST.
Memory Error
Halt
[Boot]
Enable or disable the feature to suppress OS
booting when POST detects a memory
degradation error, until user's response is
made. This option is valid only when
POST
Error Pause
is set to
Enabled
.
Even if this option is set to
Boot
, POST stops
to suppress OS booting if all of thememory
resources are degraded.
Power Switch Inhibit
[Disabled]
Enabled
Enable or disable the POWER switch inhibit
feature.
CLI SETUP
[Disabled]
Enabled
Enable or disable the Command Line
Interface SETUP feature. When this option is
set to
Enabled
, the operation of SETUP is
changed to use Command Line Interface. To
switch back to the menu operation, set this
option to
Disabled
.
For command details, execute HELP
command at CLIP SETUP prompt. If the
system is connected with bootable devices
exceeding a certain number of devices, an
error message "Failed to get Boot Variable
data" appears on command line, and the
Boot menu is not displayed or changing
parameter is disabled. In this case, reduce
the number of bootable devices by
disconnecting any USB devices not required
for bootup, or change parameter [Option
ROM Scan] for onboard device or PCI slot to
[Disabled.]
[ ]: Factory setting
