xxii
•
Use the cables provided by NEC as those connected to the disk array unit
and check the destinations to which the cables are connected. In addition,
always secure power cords and FC cables when they are connected.
•
Use a power source independent from any TV or radio. Otherwise,
interference may be generated.
•
To connect a cable to the mating connector, make sure that the connector
of the cable is not damaged and any pins are not bent. Using a cable not
approved by NEC or a damaged cable may cause a fault or fire to occur.
•
To disconnect a cable from the mating connector, always hold the
connector of the cable. Do not pull the cable itself to disconnect it.
Notes on Use of the Disk Array Unit
•
Do not let any animals (pets) or children touch the cables connected to the
disk array unit. Pulling the cable may cause the unit to fall down, resulting in
failure of the unit or personal injury.
•
Do not let any liquid such as water into the disk array unit. If so, you may be
electrically shocked or the unit may become defective. If some liquid does
enter into the disk array unit, immediately turn off the power, unplug the
power cord from AC outlet or distribution board, and contact your sales
representative or maintenance engineer. If the disk array unit seems dry,
remember, only a small amount of liquid may cause the unit to become
defective.
•
Do not let any foreign substances such as paperclips or screws into the disk
array unit through the ventilating holes on the front or rear face. If so, a fault
may occur.
•
Do not disassemble or modify the disk array unit in any way. If so, a fault or
electrical shock may occur. And, your warranty will be voided.
•
If the disk array unit will not be used for a long period of time, disconnect the
plugs of the power cords from the AC outlet or distribution board for safety.
•
It is advised that you disconnect the power plug from the outlet or
distribution board when a thunderstorm is approaching. If it starts
thundering before you disconnect the power plug, do not touch any part of
the unit including the cables. If any failure is found later, contact your sales
representative.
Summary of Contents for S2500
