- 132 -
WWN mode zoning
For WWN mode zoning, use WWPn’s of the fibre channel devices connected to the FC Switch
Module to set the zoning.
1) Checking WWPn
1.
Check WWPn’s of the fibre channel devices to be used.
For how to check WWPn’s of fibre channel devices to be used, refer to the
User’s Guides attached to the devices.
2) Creating zone
Use the "zonecreate" command to create a zone.
Use of "zonecreate" command
zonecreate "zonename" , "member;member;member"
(1)
(2)
(1) zonename:
Specify the created zone name with it enclosed by double quotation marks (").
(2) member:
Specify WWPn of a fibre channel device.
Delimit the zone name and the first WWPn with a comma (,).
Delimit adjacent WWPn specifications with a semicolon (;).
2.
Use the "zonecreate" command on the console screen to create zones.
HW060000955:admin> zonecreate
"zone1","10:00:00:00:c9:4b:a1:e5;20:01:00:30:13:84:03:d2"
HW060000955:admin> zonecreate
"zone2","10:00:00:00:c9:4b:a2:05;20:02:00:30:13:84:03:d2"
HW060000955:admin> zonecreate
"zone3","10:00:00:00:c9:4b:a1:f6;20:05:00:30:13:84:03:d2"
HW060000955:admin> zonecreate
"zone4","10:00:00:00:c9:4b:83:aa;20:06:00:30:13:84:03:d2"
HW060000955:admin>
Any commands used on the switch console should be specified with
lowercase letters.
A zone name can be up to 64 alphanumeric characters.
This command must be done by the number of zones to be created.
3.
Type "zoneshow" on the console screen.
HW060000955:admin> zoneshow
Defined configuration:
zone: zone1 10:00:00:00:c9:4b:a1:e5; 20:01:00:30:13:84:03:d2
zone: zone2 10:00:00:00:c9:4b:a2:05; 20:02:00:30:13:84:03:d2
zone: zone3 10:00:00:00:c9:4b:a1:f6; 20:05:00:30:13:84:03:d2
zone: zone4 10:00:00:00:c9:4b:83:aa; 20:06:00:30:13:84:03:d2
Effective configuration:
no configuration in effect
HW060000955:admin>
Confirm that all created zones appear by using the "zonecreate" command.
After a zone name, WWPn’s contained in the zone appear. Confirm that the
specified WWPn’s appear normally.
