SL2100 GETTING STARTED GUIDE
4
Do not touch the printer’s internal components when replacing disposables such as a
cartridge or a ribbon. Ensure that the printer is turned off and that it is not hot in order to
prevent burns from any accidental contact with the internal components.
Do not drop the peripheral equipment or knock it against another object. These actions
might cause an equipment failure.
Do not use benzine, thinner or alcohol for cleaning. When removing dust and dirt, put
diluted, mild detergent on a cloth and then wring out the cloth. Remove the dust and dirt
with the cloth and then wipe the cleaned area with a dry cloth.
Do not place any equipment in the following environments:
･
Locations that are exposed to direct sunlight
･
Locations where the moisture level exceeds the allowed level
･
Locations where the equipment might be exposed to water, oil, or chemicals
･
Locations with very low temperatures, such as in a walk-in cooler or freezer
･
Locations that are exposed to Electromagnetic Interference (EMI) from devices such
as television sets and two-way radios
･
Locations that receive illegal electric waves
The life expectancies of the system and the main power source will be shortened if
placed in a location that is affected by hydrogen sulfide or salt, such as a seaside area.
2.1 Installation Environment
Consider the following items before the installation.
2.1.1
Stability
Install the system with anchor bolts to prevent constant movement or vibration, such as
from a nearby motor or automatic door, and to resist catastrophic movement from natural
disasters, such as an earthquake. If the system moves or falls, an injury could occur.
2.1.2
Floor, Wall and Ceiling
The wall and ceiling materials must be resistant to Electrostatic Discharge (ESD) and
provide heat insulation. Since the battery’s life expectancy depends on the ambient
temperature, the room where the battery is installed must be well ventilated and vented to
the outside. Check the battery specifications to determine if the battery can or cannot be
installed near a motor or a power transformer.
The floor material that is under and around the system must be resistant to ESD.
