Issue 4.1
UNIVERGE SV8100
4 - 22
Installing the SV8100 Blades
Customer information is stored in the RAM memory and, in
case of a power failure, will be restored. The lithium battery in
the system saves the RAM memory when power is lost.
3.1.3
Switch Settings
Refer to
Table 4-5 CD-CP00 Switch Settings
for system restart/
system reset and with system power on.
Figure 4-3 CD-CP00 Blade
Layout on page 4-16
shows the location of the SW1 switch on the
CD-CP00
blade.
3.1.4
LED Indications
The LEDs on the CPU indicate the following:
Table 4-5 CD-CP00 Switch Settings
USB Memory Status
Operation
Switch
SW1 - Load
Switch
With a system restart or a system reset while holding the SW1
switch:
When USB Memory is not
installed:
Cold Start occurs.
When USB Memory is
installed:
USB Memory contents loaded.
When an unauthorized USB
device is installed:
System does not start and an “Illegal
USB device is connected” alarm is
recorded.
Table 4-6 CD-CP00 Switch 6 Settings
Configuration
Note
SW6-1
ON
Not Used
SW6-2
OFF
Test Mode
ON = Test Mode
OFF = Normal
SW6-3
OFF
RS232C Select
ON = Use
OFF = Not Used
SW6-4
ON
Reset Configuration
ON = Normal
OFF = ICE Mode
Summary of Contents for Univerge SV8100
