UNIVERGE SV8100
Issue 4.1
System Hardware Manual
R-3
EUROPEAN UNION INFORMATION
Notice to the user
The system described in this manual is intended to be connected to analog and digital networks and
supports a wide range of peripheral equipment. The following interfaces are available for connection to
public analog and digital telecommunication networks:
z
TBR3 ISDN basic rate interface
z
TBR4 ISDN primary rate interface
z
ES203-021 Analogue interface
To take advantage of all features of this system and the connected equipment, the country or network
specific features should match the supported features of the system. For an overview of the supported
features, refer to the detailed documentation that comes with this system, contact your local NEC
representative or the support desk of NEC Unified Solutions.
Declaration of conformity
Hereby, “NEC Unified Solutions”, declares that the SV8100 is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
http://www.nec-unified.com/doc
Electromagnetic Compatibility
For the SV8100 system the following warning is applicable:
Warning
This is a class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Summary of Contents for Univerge SV8100
