UNIVERGE SV8100
Issue 4.1
System Hardware Manual
4 - 69
5.1.2
Installation
Install the COIU blade into an available slot in the chassis. (Refer to
Figure 4-24 CD-4COTA Blade on page 4-67
for a layout of the
blade.)
.
If the PZ-4COTE is to be used, install this prior to inserting the CD-4COTA
blade into the chassis.
5.1.3
LED Indications
LED indications for the CD-4COTA are listed in
Table 4-34
CD-4COTA LED Indications
. Each LED is listed with its associated
function and LED and Operational status. Refer to
Figure 4-24
CD-4COTA Blade on page 4-67
for the location of the LEDs on the
blades.
Table 4-34 CD-4COTA LED Indications
LED Indication
Operation Status
Remarks
Live LED
(Green)
Busy LED
(Red)
On
On
System Initializing
–
Flash (1s)
On
The assignment of the unit is refused.
When you exceed the system
capacity.
When the main software
version is not matched.
Flash (1s)
Trouble found during self-diagnostics.
–
Flash
(100ms)
On
Normal
Operation
A Channel is busy (use
another from CH1 ~ CHx).
–
Off
All channels are idle.
–
Off
On
Unit Busy
A Channel is busy (use
another from CH1 ~ CHx).
–
Off
All channels are idle.
–
Flash (100ms
On/Off)
Downloading firmware.
–
Summary of Contents for Univerge SV8100
