Issue 4.1
UNIVERGE SV8100
4 - 70
Installing the SV8100 Blades
5.1.4
Connectors
Table 4-35 CD-4COTA RJ-61 Cable Connector Pin-Outs on page
4-70
shows the pin-outs for the RJ-61 connector. Refer to
Figure
4-24 CD-4COTA Blade on page 4-67
for an illustration showing the
location of the connectors on the 4COIU blades.
Table 4-35 CD-4COTA RJ-61 Cable Connector Pin-Outs
RJ-61 Cable Connector – CN2, Trunks
The CN2 connector is polarity sensitive (tip-to-tip, ring-to-ring).
Pin No.
Connection
1
Circuit 4 – Tip
2
Circuit 3 – Tip
3
Circuit 2 – Tip
4
Circuit 1 – Ring
5
Circuit 1 – Tip
6
Circuit 2 – Ring
7
Circuit 3 – Ring
8
Circuit 4 – Ring
RJ-61 Cable Connector – CN3, SLT Interface for Power Failure
Pin No.
Connection
1
–
2
–
3
Circuit 2 – Tip
4
Circuit 1 – Ring
5
Circuit 1 – Tip
6
Circuit 2 – Ring
7
–
8
–
Summary of Contents for Univerge SV8100
