UNIVERGE SV8100
Issue 4.1
System Hardware Manual
5 - 31
4.5.2
Configuring the Digital Telephone for the Correct Number of Line
Keys
1.
With the telephone not plugged in and the handset on-hook,
press the
4
and
6
buttons on the numbered keypad and
connect the telephone cable.
.
This places the telephone into Service Class R/W mode. The MW LED
should be lit.
2.
Press
1
to enter the Line Key Type mode.
.
The MW LED should flash.
3.
Follow the directions below for the type of line key module
installed:
4.
Save to memory by pressing line key 2, 8, 14 or 20. The display
changes back to the Service Class R/W mode and the MW
LED will be lit Red.
5.
Press
Exit
to return the telephone to the idle condition.
4.5.3
Configuring the IP Telephone for the Correct Number of Line Keys
1.
Enter the terminal’s program mode by pressing HOLD CONF
#
.
2.
At the Login screen, enter the user name (default = ADMIN)
and password (default = 6633222) and press the
OK
Soft Key.
3.
Press Soft Key
3
for Maintenance Setting.
4.
Press Soft Key
4
for Adjust.
Table 5-6 Numbered Keypad Type
Numbered Keypad Type
Push
2-Button
1
6-Button
2
8-Button
3
12-Button
4
24-Button
5
Summary of Contents for Univerge SV8100
