Issue 4.1
UNIVERGE SV8100
5 - 78
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
7.4
Installing the Bluetooth Cordless Handset
The BCH-L (BK) UNIT is an optional device that transforms the standard
multifunctional telephone into a cordless terminal. This section explains how
to transform the standard hand-set into a BCH-L (BK) UNIT. The BCH-L (BK)
UNIT cannot be connected to the DTL-2E-1 or DTL-6DE-1 telephones.
7.4.1
Installing the Bluetooth Handset Cradle
1.
Turn multiline terminal upside down.
2.
Unplug the line cord and handset cord from the multiline
terminal.
.
Only one BCH-L (BK) UNIT can be attached to the DTL multiline
terminal.
3.
Lower the tilt leg to the first position (refer to
Figure 5-93
Separate Tilt Leg from Leg Support
).
4.
Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5.
Lay the tilt leg and the leg support flat.
6.
Press the two tabs locking the legs to the multiline terminal and
pull the legs toward you, lifting to remove (refer to
Figure 5-94
Remove Legs From Multiline Terminal on page 5-79
).
Figure 5-93 Separate Tilt Leg from Leg Support
Before installing or removing the BCH-L (BK)
UNIT, remove the line cord and the AC
adapter from the outlet.
Stoppers
Tilt Leg
Summary of Contents for Univerge SV8100
