Solving Problems 5-3
START-UP PROBLEMS
The system displays an invalid configuration error message at power on
when there are the following conditions:
■
current configuration information doesn't match configuration informa-
tion stored in Auto Setup, such as when an internal option is added.
■
the system loses configuration information.
If either of these conditions is true, the system displays an “invalid configu-
ration information” message.
To continue start-up procedures, press
F1
and run Auto Setup to set current
system parameters.
If an error message appears before the operating system starts, look up the
error message in the following table. Follow the instructions. If you see other
error messages, the hardware might need repair.
NOTE
When the NEC Versa 2000 detects an error related to display
devices, it cannot display on either the LCD or a CRT. The system
warns you by beeping.
POST Error Messages
The NEC Versa 2000 has a built-in checking program that automatically
tests its components when you turn the system power on. This diagnostic
test is called the Power-On Self-Test (POST). If the system finds a problem
during the POST, the system displays an error message. If this happens, fol-
low the instructions in the POST error message table.
POST Error Messages
MESSAGE
WHAT TO DO
Diskette drive A
failure
Drive A
does not work or is not properly connected.
Drive A is the diskette drive.
Check that drive A is securely connected and power
is on.
Press
F1
to start Auto Setup to check the diskette
drive parameters.
Summary of Contents for VERSA 2000 WINDOWS 98 - UPGRADE INFORMATION
Page 41: ...About the Software 3 7...
