21
When recovery cannot be performed
If [Recovery could not be completed.] is displayed, it is possible that model
information was written incorrectly. Please contact our repair facilities.
Do not leave the computer alone during recovery
Do not leave the computer unattended until the recovery has completed including
passing all the screens that require your key operations, and power OFF.
Perform computer recovery.
There are two setup options: recovery using the "Recovery Disc", and that using the
Windows function.
Recover the computer using the DVD (Recovery Disc).
1
Turn the power on and immediately press <F2> key several times.
The BIOS setup utility will then be started.
2
When the BIOS setup utility is displayed, insert the "Recovery Disc" into
the optical drive.
3
Press the <F10> key.
4
Confirm that [Yes] is selected and then press <Enter>.
5
Turn on the power and immediately press <F2> key several times.
The BIOS setup utility will then be started.
6
From the [Boot Override] option, select the optical drive using <
> or <
> key,
and press <Enter>.
7
When the [Windows Recovery] screen is displayed, select [Restore your
computer with Recovery Disc], and press <Enter>.
8
When [Restore the Windows
8
.1 operationg system using the Recovery
Disc.] is displayed, read the precautions and press <Enter>.
9
When the [The hard disk drive will be restored to the factory default
settings. Are you sure to continue?] message is displayed, read the notes
carefully. If OK, select [Yes], and press <Enter>.
Follow the steps on the screen for the procedure.
Go to "Windows Setup" (p.23).
Computer recovery
• Recovery cannot be performed via battery power. Please be sure to connect the AC
adapter and connect the power cord to the AC outlet.
• If you are using model VG26M/C-H, you can only carry out the setup process using
the "Recovery Disc".
• If you are using model VC26M/C-H, you can only carry out the setup process using
the Windows function.
Using the "Recovery Disc"
Be sure to start operations with the computer's power turned OFF.
If the desired device is not listed on the [Boot Override] menu, press <F10> and check
to see that [Yes] is selected. Then, press <Enter>, restart the BIOS setup utility, and
select the desired device.
The [Boot Override] is contained in the [Exit] option.
Summary of Contents for VersaPro VC
Page 26: ...MEMO ...
Page 27: ...MEMO ...
