Programming Manual
May 2003
Class of Service (Attendant) Feature Selection 1
1 - 195
A
6
-324000
-642-
02 - Re
lease 6.0
May 20
03
3
Press the corresponding CO/PBX line key to enter data.
The LED indication changes to indicate the data each time a CO/PBX line key is pressed.
Note:
Use the following when entering data:
Press
S
to go to the next page
Press
T
to go to the previous page
4
Press
N
key. Data for Class 01
~
15 is displayed successively.
5
Press
N
to write the data for Class 15.
6
Press
P
to go back on-line.
Related Programming
M.B. Number
Memory Block Name
Station to Class of Service Feature Assignment
N
1. System-Wide Reset selection resets the following: Timed Alarm, Call Forward-All Call, Do Not Disturb, Customized
Message, and Callback Request.
2. Password (Outgoing Restriction) selection cancels Station Lockout and default password for another station.
3. Sixteen Classes (00
~
15) of feature restriction patterns allow a station user to activate particular features while
restricting others.
4. At default, stations 100 and 101 are in class 00. All other stations are in class 15.
5. Stations are assigned to a Class of Service in Memory Block 4-17 Station to Class of Service Feature Assignment.
6. If Terminal Exchange Mode is enabled by user on Attendant Station the PC Programming is unavailable.
7. Terminal Exchange Mode must be set to OFF on the extension to enable PC connection to function.
Programming Procedures
CO/PBX
Line Key LED
Off
On
Data
Deny Allow
Refer to Table on following page for default settings.
