1 - 98
8-Digit Matching Table to Normal Dial Assignment
NEC Business Solutions Ltd
Xen Master & Xen Axis
A
6
-324000-
642-
02 - Release 6.0
May 20
03
1-1-66
System Mode
1
Submode
1
Data No.
66
PC Programming
a
+AC
8-Digit Matching Table to Normal
Dial Assignment
General Description
Use this Memory Block to assign the 8-Digit Matching Table by class for normal dialling as
used or unused. If unused is assigned, the system does not check during normal dialling
even if Memory Block 1-1-61 8-Digit Matching Table to Class Assignment is programmed.
Display
Settings
(Page 1)
LK 1
LK 2
LK 3
LK 4
There is no default setting.
Table 00
Table 01
Table 02
Table 03
LK 5
LK 6
LK 7
LK 8
Table 04
Table 05
Table 06
Table 07
(Page 2)
LK 1
LK 2
LK 3
LK 4
Table 08
Table 09
Table 10
Table 11
LK 5
LK 6
LK 7
LK 8
Table 12
Table 13
Table 14
Table 15
Programming Procedures
1
Go off-line.
2
Press LK1 +
LK1 +
FF
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
Note:
Use the following to enter data:
S
to access the next page.
T
to access the previous page.
Each time a CO/PBX line key is pressed, the LED toggles between On
and Off.
Default Values
Tables 00~15 Used
4
Press
N
to write the data and advance to the next class. Repeat steps 3 and 4 until last class is assigned.
5
Press
N
to write the last data.
6
Press
P
to go back on-line.
Related Programming
M.B. Number
Memory Block Name
Refer to Section 6 Code Restriction in this chapter.
6 6 : N O R M A L
D I A L | 1
T I M E
D I S P L A Y
Data
No.
Setting
Data
Title
CO/PBX
Line LED
Off
On
Data
Restricted
Not restricted
There is no default setting.
