Station to Class of Service Feature Assignment
1 - 339
Programming Manual
May 2003
A6-
324000-6
42-02 -
Release 6.0
May 2003
4-17
System Mode
4
Submode
—
Data No.
17
PC Programming
a
+BTT
Station to Class of Service Feature
Assignment
General Description
Use this Memory Block to specify, per station, a class for each Table (1 and 2) to enable/
disable features.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 +
AG
to access the Memory Block.
3
Use the dial pad to enter Service Class (00 ~ 15) for Table 1.
Note:
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
for entering data
Default Values
4
Press
N
to write the data and display Table 2 data.
5
Enter Table 2 Service Class, and press
N
again.
6
Press
P
to go back on-line.
Related Programming
M.B. Number
Memory Block Name
Class of Service (Attendant) Feature Selection 1
Class of Service (Station) Feature Selection 2
N
1. Table 1 includes features that telephone ports 01 and 02 users are normally allowed to activate. Select any Class
pattern specified in Memory Block 1-8-07 Class of Service (Attendant) Feature Selection 1.
2. Table 2 includes features that all telephones users are normally allowed to activate. Select any Class pattern
specified in Memory Block 1-8-08 Class of Service (Station) Feature Selection 2.
3. Telephone ports A0~C0 are ports 100~120.
0 1 / 1 7 : C L S ( 1 )
= 0 0
T I M E
D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting Service
Class
Title
Table No.
1/2
Tel. No.
Table No.
Svc. Class
01
1 ATTN
00
2 STA
00
02
1 ATTN
00
2 STA
00
03 ~ C0
1 ATTN
15
2 STA
00
