1 - 408
Telephone Type Assignment
NEC Business Solutions Ltd
Xen Master & Xen Axis
A
6
-324000-
642-
02 - Release 6.0
May 20
03
7-2
System Mode
7
Telephone
2
Data No.
—
PC Programming
a
+BS
Telephone Type Assignment
General Description
Use this Memory Block to specify the type of device that is connected to an ESI port.
Display
Settings
LK 1
LK 2
LK 3
LK 4
The shaded area indicates the default setting.
Non
Telephone
DSS Con-
sole
SLT
Adapter
LK 5
LK 6
LK 7
LK 8
Digital
Voice Mail
Programming Procedures
1
Go off-line.
2
Press LK7 + LK2
to access the Memory Block.
3
To change data, press the corresponding CO/PBX line key.
Note:
Use the following to enter data:
R
: Next Tel Port No.
4
Press
N
to write the data.
5
Press
P
to go back on-line.
Related Programming
M.B. Number
Memory Block Name
Refer to Chapter 2 Guide to Feature Programming.
N
1. Only Multiline Terminals can be assigned to ports 01 and 02.
2. A maximum of four Attendant Add-On Consoles can be installed in the system.
3. A maximum of eight SLT(1)-U13 ADP adapters can be installed in the system.
4. A maximum of eight Digital Voice Mail ports are available.
5. When assigning SLT adapters or Digital Voice Mail ports, Memory Block 4-10 Station Number Assignment must be
reassigned also.
6. If more than one DSS console is assigned, make sure that the order of assignment is as follows:
DSS1 must always be a lower port than DSS2
DSS2 must be a lower port than DSS 3
DSS3 must be a lower port than DSS 4
0 1 : T E L
T I M E
D I S P L A Y
ESI
Port No.
(01~96)
Setting Data
