4
7
Placing Calls
If your call doesn’t go through…
Pressing CALL key after dialling an extension number is also possible.
Your call will ring or voice-announce. If you hear ringing, wait for an answer. If you hear a beep, begin
speaking. Dialling “1” changes voice/ring mode (where the destination is a Topaz Telephone).
Placing an Intercom Call <Dial Access>
Extension Number
CALL
?
?
?
Listen for Dial Tone before dialling the Telephone Number.
Placing an Outside Call <Access Code>
CALL
Telephone Number
?
?
?
?
0
Trunk Code
Listen for Dial Tone before dialling a Telephone Number.
You can have function keys for Trunks or Trunk Groups. Ask your Supplier.
Placing an Outside Call <Quick Access>
Trunk Key
Telephone Number
?
?
?
?
Repeat Dialling <Outside Call>
The system periodically redials the call. Repeat duration is programmable. Ask your NEC Authorised
Supplier for details.
You should lift the handset when the called party answered.
You can cancel this function by pressing “DC” and “LND” during idle condition.
Does not reserve line. Will select other available line when original line is in use.
Checking & Answering a Message Waiting Indication
CHECK
(On-Hook)
VOL
(Check Name)
You can check who left a message waiting indication for you, and then answer.
8
1
4
Applicable to Topaz Display Telephones only.
3
Clearing All Message Waiting Indications (at any extension)
CALL
8
7
SPK
Clears all messages you have left for other extensions and messages other extension have left for you.
(Hear Busy Tone
or No answer)
DC
LND
Repeat Dial Key
(SC.851+29)
[Flashes red when set.]
[Press flashing key to cancel.]
Cancelling a Message Waiting Indication (at originating extension)
CALL
8
7
SPK
1
Extension Number
you want to cancel MW
?
?
?
