58
Function Specification
|
Log only setting
Operation during detection
How to notify during detection
How to cancel detection state
Log output only
Log in the security log
(It is necessary to view it in Web
setting.)
－
[How to stop the security function]
When a normal website is erroneously detected as a threat, stop the function temporarily using the following method.
How to remove
Remarks
Remove by using either of the following methods:
●
Change the setting of a particular category at the
category setup from “Block“ to “Pass“. (Refer to
Section 5.8.7)
●
Remove the check on “Enable Content Filter“ from
“URL Filter setup“ to disable. (Refer to Section
5.8.7)
・
When the setting of a particular category is changed
(permitted), blocking all sites belonging to that
category is stopped.
[Check range of URL]
For this product, for HTTP traffic, it refers to both the host and path parts of the URL.
For this product, for HTTPS traffic, it refers only to the host part of the URL. (It does not refer to the path part.)
From this difference, the detection result is the same when the host part is the same even if the path part is different
for HTTPS traffic, while the detection result may be different for different paths even if the host part is the same traffic
for HTTP.
[Category list]
There are two kinds of categories.
Standard category
Individual category
Refer to the following table for the breakdown of each category.
Standard Category
No
Standard Category
Supplementary Description
1
All categories
Individual categories No.1 ~ No.62 are selected in batch.
2
Adult site category
Individual categories No.1 ~ No.10, No.13 are selected in batch.
3
Dangerous site category
Individual categories No.32 ~ No.35 are selected in batch.
4
SNS site category
Individual categories No.12, No.14, No.15, No.57, and No.58 are
selected in batch.
5
Entertainment site category
Individual categories No.11, No.16 ~ No.20 are selected in batch.
