36
Lower the buttonhole lever and gently push it
back.
①
Buttonhole lever
Slightly hold the end of the upper thread and
start sewing. Pull two lines together.
Note
- Gently feed the fabric by hand.
- Before stopping, the machine will
automatically sew a reinforcement stitch
after the buttonhole is sewn.
Raise the presser foot lifter and cut the thread.
To sew over the same buttonhole, raise the
presser foot lifter (it will return to its original
position).
After sewing the buttonhole stitch, raise the
buttonhole lever as far as it will go.
①
Buttonhole lever
Use the seam ripper to cut the center of
the buttonhole being careful not to cut any
stitches on either side. Use a pin as a stopper
at the bar tack so you do not cut too much.
Note
When cutting the buttonhole with the seam
ripper, do not place your hands in the
cutting direction, otherwise injuries may
result.
1
1
Summary of Contents for NC-59QD
