- 32 -
HEMMING (Optional)
1. Raise the foot and the needle to its
highest position. Replace the foot with
the picot foot.
2. Fold over the fabric edge by about 3 mm
and place it under the foot. Secure the
folded edge with a few stitches. Take out
the workpiece and draw the hem into the
picot foot through pulling the threads.
3. Lower the foot and sew the hem.
4. While sewing fold the fabric to the left a
little and allow it to run into the hemmer
foot.
5. Make sure that the fabric does not move
under the right half of the foot. The fabric
must be fed into the scroll of the hemmer
sufficiently so that the workpiece edge
runs freely through the groove under the
foot.
Only suitable materials can be used and
some practice may be necessary to
achieve the best results.
TWIN NEEDLE
Please place second spool pin (B) into
the position for twin needle sewing as
page 7, no. 5 pic.
Put in the twin needle with the flat side
backwards.
Thread the machine as for normal sewing,
leading both threads to needle and
passing their ends separately through its
eye.
Sewing width should not exceed the third
widest stitch width, as this will break the
needles.
ATTENTION:
When using the twin
needle, adjust the stitch width to
maximally 3. Adjusting the stitch width to
a higher number causes the needle to
break.
3 mm
1 mm
20 mm
Summary of Contents for Vigorelli M220
Page 19: ...18 LEVELLING THE MACHINE Down Up...
Page 28: ...27 BLIND STITCH 1 Fold fabric as shown 2 Finish the seam as shown...
Page 37: ......
Page 38: ......
