9 (E)
E. THREAD CUTTER BUTTON
Press this button after sewing to cut the upper
and bobbin threads.
The machine will cut both threads
automatically.
CAUTION
1. Do not press this button when there is no
fabric in the machine or no need to cut the
threads. The thread may tangle, resulting in
damage.
2. Do not use this button when cutting thread
thicker than #30, nylon thread or other
speciality threads.
In this case, use the thread cutter (H)
F. PRESSER FOOT LIFTER
The presser foot is lifed up or down by this
lever.
Note: Machine will not start when the presser
foot is lifted. (Except for bobbin winding)
G. DROP FEED LEVER
The fabric feed dogs project up through the needle plate, directly below the presser foot.
Their function is to move the fabric being sewn. The drop feed lever controls the fabric feed
dogs.
For ordinary sewing, move the lever to the right. This raises feed dogs to their highest
position. For most sewing, the lever should be in this position.
For darning or free motion embroidery or
whenever fabric is to be moved by hand,
move the lever to the left to lower the fabric
feed dogs.
H. THREAD CUTTER
Use this cutter if the thread cutter button is
not used.
1. Raise the presser foot and bring fabric
and threads backward after sewing.
2. Hook the threads to the thread cutter from
back to front.
3. Pull fabric and cut threads.
I. TOP COVER
To open the top cover, lift up the right side
of cover.
J. HAND WHEEL
By turning the hand wheel, the needle will
raise or lower. You should turn hand wheel
toward you.