20 (E)
- Model N424E -
BOBBIN SETTING
A. REMOVING THE BOBBIN
1. Pull the bobbin cover latch to the right and
remove the bobbin cover.
2. Lift up the bobbin from the machine.
B. SETTING SPOOL OF THREAD ON
20 (E)
SPOOL PIN
1. Pull up the left end of spool pin.
2. Set the spool of thread on spool pin so that the
thread unrolls from the front of the spool.
3. Set the spool cap on spool pin as far as it will go.
a: Reverse spool cap direction according to the size
of spool.
b. Use the small thread cap when you use cross
wound thread.
Leave small opening between cap and spool as
illustration.
C. WINDING THE BOBBIN
1. Hold thread in both hands and hook thread to the
guide from rear opening.
2. Bring thread frontward and pass through the thread
guide plate from rigth to left.
3. Bring thread to the right and pass thread to the
thread guide from under side. Pass through under
tension disc in counter-clockwise.
4. Insert thread through hole in bobbin and place the
bobbin on bobbin winder spindle. Push bobbin to
the right to engage bobbin winder. L.C.D. will
indicate the bobbin winding mode.
5. Hold the end of the thread and start the machine by
pressing the start/stop button or pressing the foot
controller pedal.
6. After the bobbin winds a few turns, stop the
machine by pressitng the start/stop button or
releasing the foot controller pedal. Cut the thread
near hole.
7. Start the machine again.
8. The bobbin winding will stop automatically when
bobbin is full. (Release the pedal.)
9. Push the bobbin and spindle to the left.
10 Remove the bobbin from the spindle and cut the thread.
