21 (E)
D. INSERTING THE BOBBIN
1. Place bobbin into bobbin holder with the
thread unwinding counter clockwise.
2. Draw thread into notch (a) with holding
the bobbin.
3. Pull thread along the groove from up to
down. Pull thread to the right to cut the
thread.
4. Replace the bobbin cover. Set the left
tabs into the holes in needle plate and
push the right side of bobbin cover down
until it clicks into place.
NOTE:
This machine can start to sew without
drawing up the bobbin thread.
If you want to draw up the bobbin thread,
see page 25.
