26 (E)
- Model N422E, N420E -
THREADING THE MACHINE
A. PREPARING TO THREAD MACHINE
1. Raise the presser foot lifter.
2. Press the needle up-down button and set the
needle in up position.
(Keep this position until needle eye threading.)
B. SETTING SPOOL OF THREAD ON SPOOL PIN
Open the top cover and set spool as below.
1. Pull up the left end of spool pin.
2. Set the spool of thread on spool pin so that the
thread unrolls from the front of the spool.
3. Set the spool cap on spool pin as far as it will go.
a: Reverse spool cap direction according to the size
of spool.
C. THREADING THE UPPER THREAD
1. Hold thread in both hands and pass thread to the guide from rear opening.
2. Bring thread frontward and pass through the thread guide plate from right to left.
3. Bring thread to the left and pull down thread toward you along the slit.
4. Bring thread right to left and pull up thread.
5. To thread the take-up lever, draw thread up and bring thread back down again from right
to left along the slit.
6. Pull thread downward along the slit.
7. Draw thread through thread guide from right side opening.
8. Pass through needle eye from front to back.
Refer to next page for instructions on how to use needle threader.
